Update.. it was my coolant temperature sensor causing the fans to come on, temperature hand to not work and air compressor not click on for air to wor ...


Update.. it was my coolant temperature sensor causing the fans to come on, temperature hand to not work and air compressor not click on for air to wor ...


Thank you bcm fuse 6 I had the same problem ...


Hi thanks for the information, but come to find out my fan broke while driving and hit my radiator and put a hole in it causing my car to leak fluid a ...


Ok thank you i will get the car scanned and see what comes up. ...


Update it was a t pipe or something that had a small cut in it and was replaced and so the leak stopped, leak was antifreeze. ...


first of all, you just replace the hose that's leaking. there is the: pump to hydroboost hydroboost to gear gear to pump (return line) ...


I've had multiple vehicles over the years. The most fun would be my RX-7 Turbo. But the absolute overall best vehicle I've ever owned is my current 20 ...


year, make, model, engine... needed for wiring. after the engine has come up to normal operating temperature (around 200 degrees F) are both of the ...


://newrockiesinc.zendesk.com/hc/en-us/articles/231751948-1998-2002-GMC-Savana-Chevrolet-Express?mobile_site=true ...


need more information on when and what is happening when it stalls. on the relays, relays get hot if there is a lot of load going through them. What ...


did you resurface the flywheel? or did you replace the flywheel? or did you do nothing with the flywheel? ...


Hello! Thanks for the tips! I found a great website with repair kits. I solved the problem cheaply and quickly. There were no problems with the delive ...


I would start with the throttle body cleaning. make sure the iac numbers are low. The computer may be just a little slow reacting to the sudden shut ...


I would look at your alternator to see if it is charging the battery as you drive. It kind of sounds like you are running on the battery and it is ru ...


sometimes there is a corrosion build up on the coolant outlet. did you notice any build up when you had the hose off? You may have to clean the outl ...


so what was the last scan? all the spark plugs and coils have the same age on them (in most cases) so it is not uncommon for more than one go out cl ...


wow, that's a lot of stuff. 1. ticking noise: yes, it can be an exhaust leak making a ticking noise. and as the engine heats up and the metal parts ...


what are the obd2 codes that you have now? the "P" codes... ...


what is your fluid level and what's the color and smell ...


just wondering, is the whining sound the starter spinning the engine? You may have lost compression. If the timing belt is bad or the lifter has ble ...


sorry to give you bad news but I think your may be bad. the screaming sound out of the over flow tank is just that. What coolant you have in your en ...


I'd like to get an old CJ7 for off roading ...


what was the code number? was it for lean, rich, not switching, heater...? then it should tell what sensor, B1S1, B1S2... Have you done a fuel press ...


So your knowledge and experience are very useful. I greet you. http://lan-utan-uc-se.c ...


Awnryprincess is absolutely correct. there is no camshaft sensor in this vehicle. There is a camshaft signal but it is based on the electronic ignit ...


Call a local wrecking yard and see if they have an interchange book for your trans. You will also have to check if your wire harness has the wire con ...


Good info and straight to the point. Thank you _____________ http://szybkieodchud ...


Oh by temp I additionally meant the weather not the car temp. Okay I bought the fuel pump but am going to return it now ...


I'm not sure what happened there but I think I wrote a response and posted it at the same time you wrote another post. so, on your second part about ...


Wrecking yards have interchange books that can tell you what engines are interchangeable. Call a local wrecking yard. ...


going by just part numbers, the 07 vue has a #89060390 engine part number and an 07 ion has a #19169027. But if you go online and check junkyards the ...


the crankshaft sensor tells the computer that the engine is running. It's the RPM counter. If you don't get any signal from the crankshaft sensor th ...


there are two fuses and then the trunk relay in the underhood relay box. So, both fuses are good? Should have power all the time. When you push the ...


if only one side is out I would do some checking on the circuit before I would start replacing parts. Where ro you have power and where do you have g ...


you should check with a local wrecking yard for interchangeable engines. Most have books that will say what is able to be swapped ...


you have to pull the old mast out while the motor is trying to raise the mast. When you turn the radio on and you hear the motor going, pull the mast ...


If you have a good fuel injection pulse without spark, yes you can flood the engine with gas just like a carb. But, you can check for fuel pressure, ...


Thanks for the suggestion. I took voltage measurements on it last night and got the operating voltage. With this information I can select out an LED ...


just clearing a post that was double entered and left here for a long time. Answer could be: a lot of miles on the engine. oil change interval fact ...


I do not know how to advise - the carb needs to be working correctly and you do not have the ability to check it. It is a basic automotive skill set ...


http://www.automotivetouchup.com/paint-codes/saturn.htm


I would check into the evap code. If you have the wrong solenoid open or closed it will draw gas from you fuel tank. That's why filling gas affects ...


you should scan the engine and check the coolant temperature and also look at your fuel trims. You could be running rich and flooding it. That's why ...


you are correct that the ECM turns on the fan. There are two relays. Relay fan 1 is in the underhood fuse box. relay fan2 is attached to the top co ...


first thing you should do is have your hvac system scanned for codes. Your mode door motor may have a problem, or the control panel is not sending a ...


you may want to check your torque converter clutch to see if it is stuck on. ...


you need to call a junkyard and ask them if they have the interchange book for your trans ...


check the fuses in the body control module in the left rear of the engine compartment. the park fuse may be blown ...


oh, okay. In Oregon you just have to pass with the OBD2 scan. If all the monitors show as passed and there are no codes stored, you pass. We got ri ...